by

Winix plasmawave red light

Winix plasmawave red light

Want to know more about the Winix PlasmaWave 5300 air purifier? If the light is blue, that means the air is clean. If the light is yellow, the air is decent. And lastly, if it’s red the air is poor quality.

How do you reset the check filter light on a winix?

Filter Reset Button LED light indicates when it is time to change the filter. After replacing the True HEPA Filter, use a small object such as a paper clip, to press and hold the reset button for at least 5 seconds until the Check Filter light turns off.

How do I reset my winix PlasmaWave?

Press and hold the filter reset button for 3-5 seconds. A short beep will be heard and the light should turn off. e. Place the front panel back on the unit and the air cleaner is ready to use The REPLACEMENT FILTER INDICATOR will signal when to replace/clean the HEPA Filter.

Comment

Leave a Reply

Your email address will not be published. Required fields are marked *

four × two =